Finally, install the cartridge into your printer and print a few test pages. Clean the print head with rubbing alcohol. This will help pull the ink out of the print heads, priming them and getting them ready to print. Hold the cartridge against the damp paper towel for three minutes. Then get a damp paper towel, fold it into quarters and sit the cartridge print head down onto it. Stand the cartridge upright for a few minutes before using.Wrap the cartridge in a paper towel and shake gently up and down (not sideways) 6 times.Ensure that the tape covering the printhead is removed.Includes most Dell, HP, Lexmark, and Sharp models. The print quality is not very good or the printout contains no ink This will reset the counter and allow you to use the cartridges normally. On certain Epson and Lexmark printers, if the printer is saying you cannot print due to low ink, please press and hold the "stop" or "cancel" button for 10 seconds. Although your printer will not track the ink levels, our cartridges will print fine from start to finish. Either bypass the low ink message or disable the ink level system on your printer. However, there are a small number of our cartridges that may not have been reset fully during the remanufacturing process. Please make sure to remove the plastic protective case from the cartridge.Īll of our cartridges are fully filled with ink. The shape of our compatible cartridges may look a little different from OEM cartridges, but they are designed for use in your printer, and will fit. Please try chilling the cartridge in the refrigerator (not freezer) for a couple hours before use. This is because the heat creates pressure within the sealed cartridge and that pressure blows the ink out when the cartridge is opened. (For a high temperature area) When the cartridge is opened, the ink may be bubbling/dripping out of the cartridge if it has been in a high temperature environment for a long time.Let the cartridge sit (printhead down) on a paper towel for a few minutes, then clean it up and install. The internal pressure in the vacuum is not balanced.
We suggest you open the cartridges at a sink or over your garbage can to avoid possible leaks from damaging your valuable items. Some of our cartridges may have been overfilled by the factory.
0 kommentar(er)
